The RAINSAVERMK5 is an Automatic Rainwater / Mains Water Changeover Device designed to provide automatic mains backup for Pressure Pump supply systems. The RAINSAVERMK5 is designed to be installed in conjunction with a Pressure Pump supply system that is fitted with an independent pressure and flow controller with loss of prime protection and 24 hour auto restart. No need for float switch.
Pressure System Pump Specifications BIA-JH8003S2PC20:
The pump is a submersible pressure system pump supplied wired and ready to install. The submersible pump is mounted inside the rain water tank for silent operation. Used especially for supplying water to domestic installations.
The pump is characterised by:
Automatic electronic pump control, plug and play
Automatic electronic control provides run dry protection and constant pressure at low flows. Automatic electronic control has built-in check valve and auto restart.
Corrosion resistant pump body, diffuser and impeller. Mechanical shaft seal.
240V single phase TEFC motor with in-built auto reset thermal overload
80LT/min Flow rate
RainsaverMK6 General Specifications:
Maximum water temperature (mains + pump): 40° C
Maximum recommended continuous pump flow: 120 l/m
Maximum recommended mains inlet pressure or pump pressure: 1000 kPa
2 year Rainsaver MK6 warranty, see installation and operating manual for details
WaterMark approved components AS/NZS 4020 Approved for Drinking Water
RainsaverMK6 Control Features:
Requires no power supply and consumes no electrical energy
Designed to operate with pumps and mains up to 1000 kPa (145 psi)
Pump flows to 105 l/m, mains flows to 40 l/m (at 500kPa mains)
Designed to further save water resources by reducing incoming mains to 200 kPa
Requires no weather proofing
Can be mounted any distance from the pump underground or inside a tank
Completely waterproof – Can be hosed down without the fear of electrocution
UV stabilised technopolymer for long life and good looks
All Rainsaver MK6 pumps are independently controlled to regulate flows and pressures whilst protecting the pump against voltage fluctuations, loss of water and incorporate a 24 hour automatic pump restart
WaterMark approved components for connection to all Town Water supplies. Safe against water borne bacteria, dezincification and lead poisoning
No unsightly controller power, water level float cables or the need for a dedicated controller power point
Australian owned and designed
The RAINSAVERMK6 supplies clean rainwater from a rainwater tank via an automatic pressure system pump to toilets, laundry and garden taps in a household. Mains water is also connected to the RAINSAVERMK5 as an automatic back up should rain water level be too low, or if there is a power failure.
The RS6-JH8003PMPC20 Package
Bianco JH8003PMPC2 submersible pressure system pump with auto-restart pump controller